Product Dose

It can be used as a general purpose cleaner to remove oil and grease deposits.

Using Procedure: 

  • Recommended concentration for re-circulation cleaning: 5-10%
  • Recommended concentration for manual cleaning/spraying: 10 %                                                                              

First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-20-2005-HD  is by direct injection followed by recirculation washing, using tank cleaning machines.

Spraying method

Directly spray on the contaminated area and let it act for 5-10 minutes. Then clean the system  under high pressure. A solution of 5-10% in fresh water can be used for this purpose also , and may be sprayed on and hosed off using high pressure. Circulation method :Cleaning the oil side of  tank can be cleaned by circulating through with

Rock and Roll method:-
fill the tank with water (fresh or sea) up to 25 - 30% of its volume then 5–20% (Depend on contamination) RXSOL-20-2005-HD will add , let it stand for approximately 12-24 hours. Then fill with more water to 90% of the tank's capacity. This way the tank will be cleaned by natural agitation due to wave motion. Let for a few days, then drain the tank and ballast-deballast 2-3 times in order to achieve complete and thorough rinse off.


Deposition and Contamination of coal plays important role during cleaning, For Heavy deposition RXSOL-20-2005-020 can be used concentrated ( without  dilution ) Spray the product on entire surface area and let it absorve for 15-20 minutes, then Wash with fresh or sea water. Otherwise it can be diluted up to 5 -10% depends on the deposits and contamination .