VOLC Multi Clean Emulsion Degreaser

VOLC Multi-Clean Emulsion Degreaser (RXSOL-10-1083-025) is used to remove, oil, dirt, grease, grime, and tar and asphalt residues. It is a heavy duty concentrated formula which acts as an industrial solvent to effectively clean even the greasiest of surface and equipment. The Emulsion Degreaser has a high flash point which allows it to be heated to industry specified cleaning temperatures. This makes the Emulsion Degreaser more effective cleaning agent. The solution has a very low evaporation rate and thus is not considered to be a hazardous air pollutant.  The Degreaser is readily biodegradable in nature.

Emulsion Degreaser penetrates the dirty and soiled surface, dissolves the grease and grime and flushes away dirt from the surface or the equipment.  It is an excellent way of cleaning temporary coatings from painted surfaces such as wax, oils, grease and dirt from machineries, equipment and floors and other metals. The degreaser has a polymer formulation which makes it an excellent corrosion inhibitor for 24-48 hours. It has a high viscosity that makes it cling to even vertical surfaces and ceilings in a ready-to-use formulation. Its dilution ration of up to 0.5 % gives effective results for other cleaning purposes too.

The Emulsion Degreaser is very easy to use. It can be simply sprayed, or mopped on the surface to be cleaned.  If the surface poses heavy greased condition, a scorer can be used to rub the degreaser on it. Once the Emulsion Degreaser has been applied, it needs to be left for approx.5-20 minutes depending upon the level of greasiness and dirt. After the elapsed time, the solution needs to be water off with water, preferably under pressure so that all traces of loosened dirt are removed.

The Emulsion solution can also be used as a pre-soak for equipment and surfaced to be cleaned later with steam. If the surface demands milder formulation, the degreaser can be diluted with 10 parts of water.  This diluted solution cab ne used effectively to wash tanks and swabbing off surfaces. The degreaser an be used on ferrous metals, concrete floors, temporary painted surfaces, chassis, machinery, engine blocks and shop floors.

For industrial cleaning, the degreaser can be used wither in concentrated form or in diluted from and spayed on soiled surface with an air sprayer.  Once the product acts on the surface for 5-10 minutes, the surface can be washed off with water. Reapplication may be necessary if the film to be removed is stubborn.

For increased penetration, the product may be diluted for cleaning of heavy soiled equipment and engine blocks. The product needs to be left for longer duration to allow complete solubility of all grease before washing off.

RX Marine’s Emulsion Degreaser is a strong concentrated solution that removes all kinds of grease, dirt, grime and oils. The company provides with detailed usage and safety instruction which need to be followed before using the product. One should avoid any kind of contact with the product .If contact with eyes or skin occurs, wash with ample fresh water for 15mins and seek medical attention. If accidently swallowed, drink two glasses of water and induce vomiting. Immediately seek medical attention. The degreaser contains heavy aromatic naphtha which might cause breathing issues. Always wear protective gear while working with the product. Read and follow all instruction carefully for a safe work environment.

Click here for more details